Refractory Mason

Complies to IMS system (QMS, EMS & OHSAS) requirements as set by the company.
Follows all the company policies, Regulations of (govt.& companies) and
securing the company’s Assets in line with code of conduct.
Contributes to minimization of production cost by operating the crane at its
optimum level with utmost care to minimize usage of spare parts, manpower
manhours and tools.
Reads, understands and complies to all work instructions, and safety
procedures related to his line of work as well as complying to health, and
environmental standard of the company.
Attends toolbox meeting with his crew members; addressing and contributing to
safe working practice issues, incident report discussion, housekeeping and
hazards and risk identification.
Verifies that all lifting tools and tackles being used for rigging/hoisting
are in good condition and that the usage in correct by the ground crew.
Strictly follows shift relieving policy (hand over & takeover of shift and
work site) and must ensure that he is available at work site during working
hours.
Carries out instructions and other related work being handed down by his
superior.
Carries out pre-operation check of his crane including test movements prior to
his proper shift duty and any abnormalities found shall be reported to his
immediate superior.
He shall cooperate as well as to have initiative in any projects that will
improve the safe operation of the overhead cranes.
He shall coordinate and support maintenance crew during shutdown maintenance.
Checking of refractory conditions and discussing with supervisor the
job/target for the day.
Check/inspect working condition of machines that will be used such as paddle
mixer, portable mixer, pneumatic jackhammer, vibrators, jib crane and gunning
machine/spray machine and reporting to immediate superior for need of repair
and/or replacement.
Prepare shovels, trowels, level bars, and ladders, tackles, lifting devices
and slings/chains and reporting to immediate superior for need of repair
and/or replacement
Perform proper lining on ladle, partial and/or full repair.
Perform ladle casting, ramming, patching and gunning, proper wrecking on
ladle, partial and/or full repair, proper lining on EAF partial and/or full
repair, casting of delta after leak test from alignment and checking completed
by mechanical.
Remove and change of full EBT and/or End brick and re-piping.
Perform proper wrecking of EAF hearth and working lining.
Removing tundish covers and shifting Tundish to mechanical strand
Tilting the tundish and removing the excess material.
Prepare tundish for spraying.
Perform proper spraying of Tundish, proper drying of tundish after spray.
Repair/cast damage tundish covers and tundish permanent lining.
He shall maintain clear and open communication with his superior instructions
for critical and non-routine jobs.
When in doubt, he must not send the ladle, report and wait for the instruction
given by the superior to avoid unwanted incidents.
Job Type: Full-time